![]() ![]() Even after multiple iterations, one may not get the best outcome. It is obvious that this is time consuming and expensive. If not then modify the Design -> Prototype -> Test…. The historical process is to do manual calculation, create a prototype and then check if it works as expected. Other parameters like head created, efficiency, torque on the impeller etc are as well relevant. Typical requirements of Suction Pump Designer will be to design the product for a certain amount of Suction pressure and Flow rate. It appears this application of SOLIDWORKS Flow Simulation is indeed bringing a lot of value hence why I decided to write this blog again but with a better video. ![]() To my surprise, the video has almost 48,000 hits. Wrote it and even created a video, however the blog never got published. Almost 2 years back, I thought of writing this blog. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |